850nm 2W 60*45 diffuser module
850nm VCSEL Array – 2W illumination module (preliminary)
Part Number: PT30850S12W
Product Description & Features
· 850nm Vertical-Cavity Surface-Emitting Laser illumination module
· Low wavelength-temperature sensitivity
Typical Applications
· Time of Flight(TOF)
· IR illumination
Electro-Optical Characteristics
Parameters | Symb | Min | Typical | Max | Units | Test Condition* |
Optical Output Power | POP | 1.8 | 2 | – | W | Pulse 2.9A 25℃ |
Threshold Current | Ith | – | 0.8 | 1 | A | Pulse 25℃ |
Operating Current | Iop | – | 2.9 | 3.3 | A | Pulse 25℃ |
Differential resistance | Rs | – | 220 | 350 | mΩ | Pulse 2.9A 25℃ |
Operating Voltage | Vop | – | 2.1 | 2.5 | V | Pulse 2.9A 25℃ |
Slope Efficiency | η_s | 0.8 | 1 | – | W/A | Pulse 2.9A 25℃ |
Power Conversion Efficiency | PCE | 30 | 33 | – | % | Pulse 2.9A 25℃ |
Wavelength | λpeak | 840 | 850 | 860 | nm | Pulse 2.9A 25℃ |
Spectral Width (RMS) | Δλ | – | 1 | – | nm | Pulse 2.9A 25℃ |
Beam Divergence Angle (FWHM) Long Axis | Φlong | – | 60 | – | ° | Pulse 2.9A 25℃ |
Beam Divergence Angle (FWHM) Short Axis | Φshort | – | 45 | – | ° | Pulse 2.9A 25℃ |
Wavelength coefficient | dλ/dT | – | 0.07 | – | nm/°C | Pulse 2.9A |
*All tests are under pulse condition 200Hz, 10%D.C. with heatsink temperature 25℃. Mass production wafer level test condition could vary slightly. Operating current range is for reference at engineering stage in case the typical value is not ideal for module application. Within such a current range, an acceptable PCE can be maintained, though most parameters are subjected to change if operating current is different from the suggested typical value.
Absolute Maximum Ratings
Parameter | Conditions | Units |
Operating Temperature | -20 to 85 | °C |
Storage Temperature | -40 to 105 | °C |
Stresses beyond the parameters listed under Absolute Maxim Ratings may cause permanent damage to the chips.
Shipping Instruction
The unmounted chips are shipped on adhesive blue tape rings or Gel-Pak boxes.
Copyright ©Vertilite . Note: No responsibility is assumed for the use of these products. The products can emit Class IV radiation and must be operated with extreme care. Avoid directly viewing the laser beam or exposure to specular reflections. Proper eye-wear must be worn at all times when operating. VCSEL Chips are electrostatic-sensitive device and proper ESD protection is required for handling.